Welcome, Guest

TOPIC:

cca's for 810 kit 28 Feb 2009 05:14 #268626

Bdog Topic Author Offline User Sweep the leg johnny!!! Posts: 180 Thank you received: 9	Has anyone done the 810 kit on a 750 and had problems with the stock battery or starter? Solutions? Thanks kzrider.com/forum/11-projects/338400-a-little-bit-of-an-upgrade '77 KZ650-C1 -- build 810 kit GPZ cams and carbs ZX6R front end GSXR600 Rear Kerker Dyna Accel ContiMotion tires (120/60-17&170/60-17)
	Please Log in or Create an account to join the conversation.

cca's for 810 kit 28 Feb 2009 10:11 #268664

Mark Wing Offline User Posts: 1697 Thank you received: 22	I use the kickstarter. Mark Jesus loves you Everyone else thinks your an *** 77 KZ650 C1 with ZX7 forks, GPZ mono rear, wider 18 police wheels and Yoshimura motor. Yorba Linda Cal.
	Please Log in or Create an account to join the conversation.

cca's for 810 kit 28 Feb 2009 11:31 #268680

Samwell
Offline
User
Posts: 260
Thank you received: 1

Bdog wrote:

Has anyone done the 810 kit on a 750 and had problems with the stock battery or starter? Solutions? Thanks

As long as your not bumping the compression too much, then the stock setup should be fine. It never hurts to make sure your battery is good and the connections to the starter are clean and tight.

There was a thread around here somewhere about swapping a Honda CB900 starter into the 1000cc kz's. Just search for 'honda starter' Apparently, it'll fit wih only minor mods. The stock kz starter is 0.6 kW and the Honda part is 0.8 kW, so it can spin things harder/faster. If your bike uses the 1000's starter then this is the mod for you.

hope this helps...Sam

--
Current Rides: 2013 BMW R1200GSW, 1972 BMW R75/5
Current Project: 1978 KZ1000A2: Supercrank'd by Falicon, APE studs and nuts, Dyna Green coils, powder coated frame and fenders, Stainless brake lines, dual front discs, pods, Kerker Exhaust, 1075cc with JE pistons

Please Log in or Create an account to join the conversation.

Forum

Technical Forums

Electrical

cca's for 810 kit